Oakleaf camo pants trousers 1943-45 version 2

 82.95 €  61.95 €
In Stock
Shipping from 3.52 €

How to choose the size?

To measure your waist you should use a flexible meter, or at least a rope. You can compare data from table below with any pants that you have and that fit you.

  • Maximum waist — the maximum girth of a bare waist that will fit into these pants. Waistband is pulled down by 12 cm with two strips on sides. We strictly do not advise taking the pants "skin-close" (otherwise it is difficult to bend over them), your girth should be 2-5 cm below the maximum for the selected size. By the way, the belt of these pants is high, and you need to measure your waist at the navel. If you want to wear pants over field trousers, the maximum waist should be measured over field trousers!
  • Pants length — the full length of the pants along the outer seam. The ends of the pants are tucked into boots or Gamaschen, so the pants should end at ankles. If you are higher than 180 cm, your pants may seem short, but in fact this is not important, because the ends of the trousers are always in boots, they are not visible. We never have pants of another length!

The main size of the pants is the waist circumference. You need to start with it. Other sizes either depend on it or are listed for reference. If you choose the size according to the principle “well, I wear L”, then you can be mistaken, because L is a conditional size, which means simply “large”.

Compliance is true for this product only!
Iternational sizeJeans sizeRussian sizeMaximum girth, cmPants lenght, cm

If you do not understand the table and you need help, write or call us, we will help you to find the size.

You can choose the size you need from those in the list near "Add to Cart" button. If we don't have any size, you won't find it there. Other sizes may appear later.


Pants for the "Oakleaf" suit.

Jackets and pants in the "Oakleaf" camouflage in this form will no longer be produced, we sell what we have in stock. But we have (and will offer) other "Oakleaf" suits. If there is no suitable size in this product, then it is most likely in another similar product.

2 side pockets, front pocket for a watch/compass. Pants can be worn with a belt or suspenders (you may have to sew more buttons to wear suspenders, buttons can be purchased from us or simply use conventional plastic). 2 tabs with buckles at the back for waist tightening. The pants-legs have tabs; their ends go in the slots at the bottom of the leg. They do not allow pants-legs to lift up and pull them on the ankle at the same time.

Attention! If you plan to wear these trousers with suspenders, you should buy 4 buttons 17 mm (metal or plastic) to sew them on the front of the belt, from the inside.

What to do with the tape at the bottom of the leg?

The forked tape at the bottom is the heel strap. It should be passed through the gap at the bottom of the pants and tied as shown in the photo. You can choose the length according to your height. This simple device tightens the trouser leg around the ankle and doesn't let trouser to fall out of the boot when you standing. If you need to take off the pants, it is enough to remove the strap from the heel, and the pants-leg will relax in width, allowing you to stick your leg.

The blue color of the socks for the contrast of the details in the photo.